LAN10FAT Network Card Settings and Configuration
ZENITH DATA SYSTEMS
LAN10FAT
NIC Type | Ethernet |
Transfer Rate | 10Mbps |
Data Bus | 16-bit ISA |
Topology | Linear Bus |
Wiring Type | 50/62.5/80/100µ fiber optic cable |
Boot ROM | Available |
CONNECTIONS | |
Purpose | Location |
SMA/ST Receive Connector (gray) | CN1 |
SMA/ST Transmit Connector (black) | CN2 |
BASE MEMORY ADDRESS | ||
Address | JP1 | |
» | CC00h | Closed |
| D000h | Open |
INTERRUPT REQUEST | ||
IRQ | JP2 | |
» | 5 | Closed |
| 10 | Open |
ROM ENABLE | ||
Setting | JP3 | |
» | Disabled | Open |
| Enabled (at address D800h) | Closed |
CABLE LENGTH | ||
Cable length between two furthest nodes | JP4 | |
» | Less than 1Km (normal distance) | Pins 1 & 2 Closed |
| More than 1Km (extended distance) | Pins 2 & 3 Closed |
DIAGNOSTIC LED(S) | ||
LED | Status | Condition |
LED1 | On | Card is configured correctly and operating normally |
LED1 | One blink | Data is not being received (receive link is down) |
LED1 | Two blinks | Card is jabbering (transmitting continuously) |
LED1 | Three blinks | Data is not being transmitted (transmit link is down) |
LED1 | Four blinks | Card detected a remote fault |
LED1 | Five blinks | Illegal data was input to the card |
My Books
