EW-1000 Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	8-bit ISA
Topology	Linear Bus
Wiring Type	RG58A/U 50ohm coaxial AUI transceiver via DB-15 port
Boot ROM	Not available

CABLE TYPE
Type		W1A - W1F
»	RG58A/U 50ohm coaxial	Closed
	AUI transceiver via DB-15 port	Open

ETHERNET VERSION
Setting		W2
»	Version 2 (IEEE 802.3)	Open
	Version 1	Closed

SEGMENT LENGTH
Maximum Length		W3
»	185 meters	Closed
	300 meters	Open
Note:The cable segment length option is only valid when the cable type is RG58A/U 50ohm coaxial.

WAIT STATE
Setting		PC/AT System speed	W4A
»	4 wait states	8 - 16MHz	Open
	2 wait states	6MHz	Closed
Note:This option is ignored if the card is installed in an IBM PC, PC/XT, or PS/2 Model 30.

I/O BASE ADDRESS
Address		W4B	W4C	W4D	W4E
	200h	Closed	Closed	Closed	Closed
	220h	Open	Closed	Closed	Closed
	240h	Closed	Open	Closed	Closed
	260h	Open	Open	Closed	Closed
»	280h	Closed	Closed	Open	Closed
	2A0h	Open	Closed	Open	Closed
	2C0h	Closed	Open	Open	Closed
	2E0h	Open	Open	Open	Closed
	300h	Closed	Closed	Closed	Open
	320h	Open	Closed	Closed	Open
	340h	Closed	Open	Closed	Open
	360h	Open	Open	Closed	Open
	380h	Closed	Closed	Open	Open
	3A0h	Open	Closed	Open	Open
	3C0h	Closed	Open	Open	Open
	3E0h	Open	Open	Open	Open

INTERRUPT REQUEST
IRQ		W5A	W5B	W5C	W5D	W5E	W5F
	2/9	Open	Open	Open	Open	Open	Closed
»	3	Open	Open	Open	Open	Closed	Open
	4	Open	Open	Open	Closed	Open	Open
	5	Open	Open	Closed	Open	Open	Open
	6	Open	Closed	Open	Open	Open	Open
	7	Closed	Open	Open	Open	Open	Open