CS-MORITZ Network Card Settings and Configuration
COMPU-SHACK PRODUCTION, GMBH
CS-MORITZ
NIC Type: | Ethernet |
Transfer Rate: | 10Mbps |
Data Bus: | 16-bit ISA |
Topology: | Linear Bus Star |
Wiring Type | RG58A/U 50ohm coaxial Shielded/Unshielded twisted pair |
Boot ROM | Available |
8/16-BIT BUS SELECT | ||
Setting | J3 | |
| » | 16-bit | Open |
8-bit | Closed | |
TERMINATING RESISTOR | ||
Setting | J4 | |
| » | Disabled | Open |
Enabled | Closed | |
FACTORY CONFIGURED SETTINGS | |
Jumper | Setting |
J5 | Closed |
J6 | Jumper A closed, jumpers B-H open |
J7 | Jumpers A-H: N/A |
J8 | Jumpers A-H: N/A |
DIAGNOSTIC LEDS | |||
LED | Color | Status | Condition |
D1 | Yellow | Blinking | Data is being transmitted |
D2 | Yellow | Blinking | Data is being received |
D3 | Yellow | Blinking | Collision detected on network (RG-58A/U coaxial connection only) |
D4 | Green | On | Twisted pair network connection is good |
D5 | Red | On | Twisted pair network connection is broken |
D6 | Yellow | On | Transmission interrupted due to data packet is too long (jabber) |
My Books
