MY IN MODEM modem/telephone/ISDN Settings and Configuration

Card Type	Fax, Modem (asynchronous)
Chip Set	Unidentified
Maximum Data Rate	14.4Kbps
Maximum Fax Rate	14.4Kbps
Data Bus	8-bit ISA
Fax Class	Class I & II
Data Modulation Protocol	Bell103/212A/2400 ITU-T V.21, V.22, V.22bis, V.23, V.32, V.32bis
Fax Modulation Protocol	ITU-T V.17, V.27ter, V.29
Error Correction/Compression	MNP5, V.42, V.42bis

CONNECTIONS
Function	Label
Line out		CN1

SERIAL PORT ADDRESS
Setting	JP1/6	JP1/7
COM1 (3F8h)	Closed	Closed
COM2 (2F8h)	Closed	Open
COM3 (3E8h)	Open	Closed
í COM4 (2E8h)	Open	Open

INTERRUPT
Setting	JP1/1	JP1/2	JP1/3	JP1/4	JP1/5
2	Closed	Open	Open	Open	Open
í 3	Open	Closed	Open	Open	Open
4	Open	Open	Closed	Open	Open
5	Open	Open	Open	Closed	Open
7	Open	Open	Open	Open	Closed

SUPPORTED COMMAND SET

Basic AT Commands

AT, ‘+++’, ‘Comma’, A/

A, B, D, E, H, I, L, M, N, O, P, Q, S, T, V, W, X, Y, Z

&C, &D, &F, &G, &K, &L, &P, &R, &S, &T, &V, &W, &Y, &Z

Extended AT Commands

\A, \B, \G, \L, %C, %L, %Q

S Registers

S0, S1, S2, S3, S4, S5, S6, S7, S8, S9, S10, S11, S12, S16, S18, S21, S22, S24, S25, S26, S29

S30 S32, S33, S36, S37, S38, S39, S46, S48, S82, S86, S95

Note: See MHI Help file for full command documentation.

MODULATION SELECTION
Type:	Configuration
Format:	AT [cmds] Fn [cmds]
Description:	Controls line modulation unless automode is selected
Command		Function
F0		Automode enabled
F1		Force V.21 or Bell103 (according to ATB command) at 300bps
F2		‘OK’ returned
F3		Force V.23 75TX/1200RX originate or 1200TX/75RX answer FSK
F4		Force V.22 or Bell212A (according to ATB command) at 1200bps
F5		Force V.22bis or Bell2400 (according to ATB command)
F6		Force V.32 at 4800bps
F7		Force V.32 at 7200bps
F8		Force V.32 at 9600bps
F9		Force V.32bis at 12000bps
F10		Force V.32bis at 14400bps