KT-IDE PLUS-V2 Hard Disk/Floppy Controller Settings and Configuration

Data bus:	16-bit, ISA
Size:	Half-length, full-height card
Hard drive supported:	Two IDE(AT) Interface drives
Floppy drives supported:	Two 360KB, 720KB, 1.2MB, or 1.44MB drives

CONNECTIONS
Function	Location
40-pin IDE(AT) Interface connector	CN1
34-pin control cable connection - floppy drive	CN2
10-pin serial port 2 - internal	CN3
10-pin serial port 1 - internal	CN4
15-pin game port - external	CN5
25-pin parallel port - external	CN6
2-pin connector - Drive Active LED	CN7

PARALLEL PORT CONFIGURATION
LPT		Jumper JP1	Jumper JP2
»	LPT3 (278-27Fh)	pins 1-2 closed	pins 1-2 closed
	LPT2 (378-37Fh)	pins 2-3 closed	pins 1-2 closed
	LPT1 (3BC-3BFh)	pins 1-2 closed	pins 2-3 closed
	Disabled	pins 2-3 closed	pins 2-3 closed

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Floppy drive enabled	JP6	pins 1-2 closed
	Floppy drive disabled	JP6	pins 2-3 closed
»	Two floppy drives supported	JP7	pins 1-2 closed
»	Factory configured - do not alter	JP7	pins 2-3 closed
»	Factory configured - do not alter	JP9	unknown
»	Factory configured - do not alter	JP10	unknown

SERIAL PORT CONFIGURATION
CN4	CN3	Jumper JP3	Jumper JP4	Jumper JP5
COM1	COM2	pins 1-2 closed	pins 1-2 closed	pins 1-2 closed
COM2	COM1	pins 1-2 closed	pins 1-2 closed	pins 2-3 closed
COM1	Disabled	pins 1-2 closed	pins 2-3 closed	pins 1-2 closed
COM2	Disabled	pins 1-2 closed	pins 2-3 closed	pins 2-3 closed
Disabled	COM2	pins 2-3 closed	pins 1-2 closed	pins 1-2 closed
Disabled	COM1	pins 2-3 closed	pins 1-2 closed	pins 2-3 closed
Disabled	Disabled	pins 2-3 closed	pins 2-3 closed	pins 1-2 closed
Disabled	Disabled	pins 2-3 closed	pins 2-3 closed	pins 2-3 closed