KT-IDE PLUS-V1(VER. 2) Hard Disk/Floppy Controller Settings and Configuration

Data bus:	16-bit, ISA
Size:	Half-length, full-height card
Hard drive supported:	Two IDE(AT) Interface drives
Floppy drives supported:	Two 360KB, 720KB, 1.2MB, or 1.44MB drives

CONNECTIONS
Function	Location
10-pin serial port 1 - internal	CN1
10-pin serial port 2 - internal	CN2
34-pin control cable connection - floppy drive	CN3
40-pin IDE(AT) Interface connector	CN4
Game port	CN5
Parallel port	CN6
2-pin connector - drive active LED	CN7

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Game port enabled	JP2	closed
	Game port disabled	JP2	open
»	Factory configured - do not alter	JP6	pins 1 & 2 closed
»	Parallel port IRQ7 selected	JP7	pins 2 & 3 closed
	Parallel port IRQ5 selected	JP7	pins 1 & 2 closed

PARALLEL PORT CONFIGURATION
LPT/Address		JP3
»	LPT1/378h	pins 2 & 3 closed
	LPT2/278h	pins 1 & 2 closed
	Disabled	all pins open

SERIAL PORT 1 CONFIGURATION
COM/Address		JP5
»	COM1/3F8h	pins 2 & 3 closed
	COM3/3E8h	pins 1 & 2 closed
	Disabled	all pins open

SERIAL PORT 2 CONFIGURATION
COM/Address		JP4
»	COM2/2F8h	pins 2 & 3 closed
	COM4/2E8h	pins 1 & 2 closed
	Disabled	all pins open