LCS-6611/W Hard Disk/Floppy Controller Settings and Configuration
LCS-6611/W
Data bus: | 16-bit, ISA |
Size: | Full-length, full-height card |
Hard drive supported: | Two MFM ST506/412 drives |
Floppy drives supported: | None |
CONNECTIONS | |
Function | Location |
4-pin connector - drive active LED | J1 |
20-pin data cable connector - drive 1 | J2 |
20-pin data cable connector - drive 0 | J3 |
34-pin control cable connector - hard drive | J4 |
USER CONFIGURABLE SETTINGS | |||
Function | Location | Setting | |
| » | Hard drive primary address select | J5 | pins 1 & 2 closed |
Hard drive alternate address select | J5 | pins 2 & 3 closed | |
| » | Hard drive LED in latch mode | J7/A | open |
Hard drive LED in non-latch mode | J7/A | closed | |
| » | Factory configured - do not alter | J7/B | open |
| » | Hard drive incompatible with WD1003-WAH | J7/C | open |
Hard drive compatible with WD1003-WAH | J7/C | closed | |
| » | Bracket and ground are unconnected | J8 | open |
Bracket and ground are connected | J8 | closed | |
My Books
