LCS-6610HX Rev. 2 Hard Disk/Floppy Controller Settings and Configuration
LONGSHINE MICROSYSTEM, INC.
LCS-6610HX Rev. 2
Data bus: 16-bit, ISA
Size: Half-length, full-height card
Hard drives supported: Two MFM ST506/412 drives
Floppy drives supported: None
Max. Heads and Cyls.: 16 Heads and 1024 Cyls.
CONNECTIONS | |
Function | Location |
4-pin connector-drive active LED | CN1 |
20-pin data cable connector-drive 0 | CN2 |
20-pin data cable connector-drive 1 | CN3 |
34-pin control cable connector-hard drive | CN4 |
USER CONFIGURABLE SETTINGS | |||
Function | Location | Setting | |
| » | Hard drive port address is 1F0-1F7h | JP4 | open |
Hard drive port address is 170-177h | JP4 | closed | |
| » | BIOS other than DTK on host | JP5 | closed |
DTK BIOS on host | JP5 | open | |
| » | LCS-6610HX is not grounded to host | JP7 | open |
LCS-6610HX is grounded to host | JP7 | closed | |
Note:Jumper JP1, JP3, and JP8 are reserved and must be left "open."JP9 is reserved and must be left pins 1 & 2 "closed."This controller contains no on-board software. | |||
My Books
