LAN10E-MC Network Card Settings and Configuration
ZENITH DATA SYSTEMS
LAN10E-MC
NIC Type | Ethernet |
Transfer Rate | 10Mbps |
Data Bus | 32-bit MCA |
Topology | Linear Bus |
Wiring Type | AUI transceiver via DB-15 port RG--58A/U 50ohm coaxial |
Boot ROM | Available |
BOOT ROM SIZE | ||
Size | JP1 | JP2 |
16KB | Pins 1 & 2 Closed | Pins 1 & 2 Closed |
32KB | Pins 2 & 3 Closed | Pins 1 & 2 Closed |
64KB | Pins 2 & 3 Closed | Pins 2 & 3 Closed |
CABLE TYPE | ||
Type | JP4A - JP4F | |
| » | RG--58A/U 50ohm coaxial | Closed |
AUI transceiver via DB-15 port | Open | |
SIGNAL QUALITY | ||
Setting | JP8 | |
| » | SQE test disabled | Pins 2 & 3 Closed |
SQE test enabled | Pins 1 & 2 Closed | |
Note:Signal Quality Error (SQE) is an internal test of the collision circuitry and path. | ||
POLARITY CORRECTION | ||
Automatic Polarity Correction | JP9 | |
| » | Enabled | Pins 2 & 3 Closed |
| Disabled | Pins 1 & 2 Closed | |
Note:With automatic polarity correction enabled, the card will sense if the receive wires are reversed and
| ||
My Books
