LanCard/E * MC 10BT Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	MCA
Topology	Linear Bus Star
Wiring Type	Shielded twisted pair Unshielded twisted pair AUI transceiver via DB-15 port
Boot ROM	Not Available

CABLE TYPE
Connector type	JP1 - JP4
Shielded/Unshielded twisted pair	Pins 1 & 2 closed
AUI transceiver via DB-15 port	Pins 2 & 3 closed

10BASE-T CONFIGURATION
Setting		JP5 & JP6
»	10BASE-T receive level select standard	Pins 2 & 3 closed
	10BASE-T receive sensitivity reduced by 4.5db	Pins 1 & 2 closed

LINK INTEGRITY TEST
Setting		JP7
»	Enabled	Pins 1 & 2 closed
	Disabled	Pins 2 & 3 closed
Note:Link Integrity is only used with 10Base-T wiring. When using an AUI transciever, the test should be disabled.

ETHERNET GROUNDING CONFIGURATION
Setting		JP8
»	DB-15 port pin #1 select logic ground (Ethernet standard)	Pins 2 & 3 closed
	DB-15 port pin #1 select chassis ground (Older DIX standard)	Pins 1 & 2 closed

DIAGNOSTIC LED(S)
LED	Status	Condition
1	On	Data is being received
1	Off	Data is not being received
2	On	Data is being transmitted
2	Off	Data is not being transmitted
3	On	Collision is detected on network
3	Off	No collisions detected on network
4	On	Network connection is good
4	Off	Network connection is broken
L5	On	Power on
L5	Off	Power off