EtherCard PLUS Elite10T Network Card Settings and Configuration
STANDARD MICROSYSTEMS CORPORATION
EtherCard PLUS Elite10T
NIC Type | Ethernet |
Transfer Rate | 10Mbps |
Data Bus | 8-bit ISA |
Topology | Linear bus Star |
Wiring Type | Unshielded twisted pair AUI transceiver via DB-15 port |
Boot ROM | Available |
NETWORK CARD CONFIGURATION | ||||||
I/O Base Address | IRQ | Base Address | JP1A | JP1B | JP1C | |
» | 280h | 3 | D0000h | Open | Closed | Open |
| 300h | 5 | CA000h | Open | Open | Closed |
| Software setup | Software setup | Software setup | Closed | Open | Open |
BOOT ROM ADDRESS | |||
Setting | JP2A | JP2B | |
» | Software Setup/Disabled | Closed | Open |
| D8000h | Open | Closed |
DIAGNOSTIC LED(S) | ||
LED | Status | Condition |
LED1 | On | Twisted pair network connection is good |
LED1 | Off | Twisted pair network connection is broken |
LED2 | On | Data is being transmitted |
LED2 | Off | Data is not being transmitted |
LED3 | On | Data is being received |
LED3 | Off | Data is not being received |
My Books
