MICRONET STATION BOARD Network Card Settings and Configuration
NETWORK DEVELOPMENT CORPORATION
MICRONET STATION BOARD
NIC Type | Device Network Architecture (DNA) |
Transfer Rate | 2Mbps |
Data Bus | 8-bit ISA |
Topology | Linear bus |
Wiring Type | Shielded/Unshielded twisted pair (1 male, 1 female DB-9 connector) |
Boot ROM | Not available |
I/O BASE ADDRESS | |||
Address | JP1A | JP1B | |
| » | 2E0h | Open | Open |
2E8h | Closed | Open | |
3E0h | Open | Closed | |
3E8h | Closed | Closed | |
INTERRUPT REQUEST | |||||
IRQ | JP2A | JP2B | JP2C | JP2D | |
2/9 | Closed | Open | Open | Open | |
3 | Open | Closed | Open | Open | |
4 | Open | Open | Closed | Open | |
| » | 5 | Open | Open | Open | Closed |
Disabled | Pin one of JP2A and JP2B closed | ||||
SLOT EIGHT ENABLE | ||
Setting | JP8 | |
| » | Disabled | Closed |
Enabled | Open | |
Note:If the card is installed in slot 8 of an IBM XT or compatible this option must be enabled. | ||
NODE ADDRESS | |||
Node | SW1/1 | SW1/2 | SW1/3 |
0 | Off | Off | Off |
1 | On | Off | Off |
2 | Off | On | Off |
3 | On | On | Off |
4 | Off | Off | On |
5 | On | Off | On |
6 | Off | On | On |
7 | On | On | On |
Note:Each station card must have a unique node address. | |||
FACTORY CONFIGURED SETTINGS | |
Switch | Setting |
SW1/4 | Unused |
My Books
