TPAIR-426, 6-PORT 10BASE/T HUB CARD Network Card Settings and Configuration
INTELLICOM, INC.
TPAIR-426, 6-PORT 10BASE/T HUB CARD
NIC Type | Ethernet |
Transfer Rate | 10Mbps |
Data Bus | 8/16-bit ISA |
Topology | Star |
Wiring Type | Unshielded twisted pair (6 RJ-45 ports) |
Boot ROM | Not available |
CONNECTORS | |
Funciton | Location |
Inter-bus connector | CON7 |
TPair-410 AUI connector | CON8 |
Note:The Inter-bus connector is used to connect the card to other TPair-406's and TPair-426's to form a Hub-group. Up to four TPair 406's or three TPair-406's and one TPair-426 can be attached in a cascade fashion via the Inter-bus connectors and the supplied ribbon cable. The TPair-410 AUI connector is used to connect a TPair-406 to a TPair-410. Only one TPair-410 may be used per Hub-group. | |
I/O BASE ADDRESS | ||
Setting | JP1 | |
| » | 300h | Pins 1 & 2 Closed |
320h | Pins 2 & 3 Closed | |
INTERRUPT REQUEST | |||||
Interrupt | JP4A | JP4B | JP4C | JP4D | |
2/9 | Closed | Open | Open | Open | |
| » | 3 | Open | Closed | Open | Open |
4 | Open | Open | Closed | Open | |
5 | Open | Open | Open | Closed | |
DMA CHANNEL | |||||
Channel | JP5A | JP5B | JP6A | JP6B | |
| » | Disabled | Open | Open | Open | Open |
DMA1 | Closed | Closed | Open | Open | |
DMA3 | Open | Open | Closed | Closed | |
DIAGNOSTIC LED(S) | ||
LED | Status | Condition |
LED1 | On | Network connection is good (CON1) |
LED1 | Off | Network connection is broken (CON1) |
LED2 | On | Network connection is good (CON2) |
LED2 | Off | Network connection is broken (CON2) |
LED3 | On | Network connection is good (CON3) |
LED3 | Off | Network connection is broken (CON3) |
LED4 | On | Network connection is good (CON4) |
LED4 | Off | Network connection is broken (CON4) |
LED5 | On | Network connection is good (CON5) |
LED5 | Off | Network connection is broken (CON5) |
LED6 | On | Network connection is good (CON6) |
LED6 | Off | Network connection is broken (CON6) |
My Books
