MODEL 1500 Network Card Settings and Configuration
ANSEL COMMUNICATIONS, INC.
MODEL 1500
NIC Type | Ethernet |
Transfer Rate | 10Mbps |
Data Bus | 16-bit ISA |
Topology | Linear bus |
Wiring Type | Unshielded twisted pair
|
Boot ROM | Available |
WAIT STATE CONFIGURATION | |
Wait State(s) | W1 |
0 wait states | Open |
1 wait state | Closed |
CABLE TYPE | ||||||||
Type | W2 | W3 | W4 | W5 | W6 | W7 | W8 | W9 |
Unshielded twisted pair | 2 & 3 | 1 & 2 | 2 & 3 | 2 & 3 | 2 & 3 | 2 & 3 | 2 & 3 | 2 & 3 |
AUI transceiver via DB-15 | 1 & 2 | 1 & 2 | 1 & 2 | 1 & 2 | 1 & 2 | 1 & 2 | 1 & 2 | 1 & 2 |
Note:Pins designated should be in the closed position. | ||||||||
LOOPBACK TEST MODE | ||
Mode | W3A | |
| » | Loopback test mode disabled | Open |
Loopback test mode enabled | Closed | |
DMA CHANNEL | ||||||||
Channel | W10 | W11 | W12 | W13 | W14 | W15 | W16 | W17 |
DMA3 | Closed | Open | Open | Open | Closed | Open | Open | Open |
DMA5 | Open | Closed | Open | Open | Open | Closed | Open | Open |
DMA6 | Open | Open | Closed | Open | Open | Open | Closed | Open |
DMA7 | Open | Open | Open | Closed | Open | Open | Open | Closed |
BOOT ROM | ||
Setting | W18 | |
| » | Disabled | Open |
Enabled | Closed | |
BASE I/O ADDRESS | |||
Address | W19 | W20 | |
| 300h | Closed | Closed | |
320h | Closed | Open | |
| » | 340h | Open | Closed |
360h | Open | Open | |
INTERRUPT SETTINGS | ||||
IRQ | W21 | W22 | W23 | W24 |
3 | Open | Open | Closed | Open |
4 | Open | Closed | Open | Open |
5 | Closed | Open | Open | Open |
9 | Open | Open | Open | Closed |
DIAGNOSTIC LED(S) | |||
LED | Color | Status | Condition |
L1 | Green | Off | Link integrity exists |
L1 | Green | On | Link integrity broken |
L2 | Red | On | NIC receiving power from PC |
L2 | Red | Off | No power from PC/NIC failure |
Note:L1 is only functional when link integrity is enabled. | |||
My Books
