AICEther-8/10BT (No Boot ROM) Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	8-bit ISA
Topology	Star
Wiring Type	Unshielded twisted pair
Boot ROM	Not available

SEGMENT LENGTH
Maximum Segment Length	JP1
100 meters	Closed
300 meters	Open
Note:Segment length is the distance from the card to the hub.

I/O BASE ADDRESS
Address		JP2D	JP2E
	200h	Closed	Closed
	210h	Closed	Open
»	300h	Open	Closed
	310h	Open	Open

INTERRUPT REQUEST
IRQ		JP2F	JP2G	JP2H
	2	Closed	Open	Open
»	3	Open	Closed	Open
	5	Open	Open	Closed

RECEIVE WIRE POLARITY
Mode		SW1
»	Normal	On
	Inverted	Off
Note:If the diagnostic LEDs indicate that the receive wires' polarities are reversed (LED1 Off, Hub LED On) you can

TX/RX CROSSOVER
Mode		SW2
»	Normal	On
	Crossover	Off
Note:If the diagnostic LEDs indicate that the transmit & receive wires are reversed (LED1 Off, Hub LED Off) you can correct the problem by using the crossover option.

FACTORY CONFIGURED SETTINGS
Jumper	Setting
JP2A	Unused
JP2B	Unused
JP2C	Unused
JP4	Unused

DIAGNOSTIC LED(S)
LED1	Hub LED	Condition
On	On	Network connection is good
Off	Off	Transmit/Receive crossover at card
On	Off	Receive polarity reversed at hub
Off	On	Receive polarity reversed at card
Note:The Hub LED is located on the hub, not on the card.