AICETHER-8/10BT (BOOT ROM VERSION) Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	8-bit ISA
Topology	Star
Wiring Type	Unshielded twisted pair
Boot ROM	Available

INTERRUPT REQUEST
IRQ		JP9A	JP9B	JP9C	JP9D	JP9E	JP9F
	2	Open	Open	Open	Open	Open	Closed
»	3	Open	Open	Open	Open	Closed	Open
	4	Closed	Open	Open	Open	Open	Open
	5	Open	Open	Open	Closed	Open	Open
	6	Open	Closed	Open	Open	Open	Open
	7	Open	Open	Closed	Open	Open	Open

I/O BASE ADDRESS
Address		JP9G	JP9H
	200h	Closed	Closed
	210h	Open	Closed
»	300h	Closed	Open
	310h	Open	Open

BOOT ROM
Setting		JP13
»	Disabled	Open
	Enabled	Closed
Note:Location of the boot ROM may vary on different revisions of this card.

BOOT ROM ADDRESS
Address	JP14A	JP14B
C800h	Closed	Closed
CC00h	Closed	Open
D000h	Open	Closed
D400h	Open	Open

RECEIVE WIRE POLARITY
Mode		SW1
»	Normal	On
	Inverted	Off
Note:If the diagnostic LEDs indicate that the receive wires' polarities are reversed at the card (LED1 Off, Hub LED

TX/RX CROSSOVER
Mode		SW2
»	Normal	On
	Crossover	Off
Note:If the diagnostic LEDs indicate that the transmit & receive wires are reversed (LED1 Off, Hub LED Off) you can correct the problem by using the crossover option.

DIAGNOSTIC LED(S)
LED1	Hub LED	Condition
On	On	Network connection is good
Off	Off	Transmit/Receive crossover at card
On	Off	Receive polarity reversed at hub
Off	On	Receive polarity reversed at card
Note:The Hub LED is located on the hub, not on the card.