PIPELINE 400 T1 modem/telephone/ISDN Settings and Configuration

Card Type	T1 Remote Access Server
Chip Set	Unidentified
I/O Options	Power connector, 10BaseT Hut via RJ-45 connectors (12), 15-pin AUI port, BNC connector, UTP interface via RJ-45 connector T1/PRI interface via RJ-45 connectors (2), 9-pin serial port
Wiring Type	Unshielded twisted pair AUI transceiver via DB-15 port RG-58A/U 50ohm coaxial
Ethernet Transfer Rate	10Mbps
T1 Transfer Rate	Unidentified
ISDN Rate	Unidentified
ISDN Modulation Protocol	PPP, SLIP, X25, MLPPP
Error Correction/Compression	Unidentified
Data Bus	External

CONNECTIONS
Function	Label	Function	Label
Power	CN1	10BaseT Hut (optional)	CN5-CN16
9-pin serial port	CN2	15-pin AUI port	CN17
T1/PRI interface (RJ-45)	CN3	BNC connector	CN18
T1/PRI interface (RJ-45)	CN4	UTP interface (RJ-45)	CN19

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
PWR	Unidentified	On	Power is on
PWR	Unidentified	Off	Power is off
ACT	Unidentified	Blinking	Data is being transmitted/received on Ethernet interface
ACT	Unidentified	Off	Data is not being transmitted/received on Ethernet interface
COL	Unidentified	Blinking	Collisions are being detected on Ethernet interface
COL	Unidentified	Off	Collisions are not being detected on Ethernet interface
WAN	Unidentified	On	WAN session is active
WAN	Unidentified	Blinking	Error detected on BRI interface
WAN	Unidentified	Off	Connection is broken on BRI interface
CON	Unidentified	On	Unit is connected to power source; power-up test in progress
CON	Unidentified	Off	Unit is not connected to power source; power-up test not in progress