WY-964 Hard Disk/Floppy Controller Settings and Configuration
WYSE TECHNOLOGY, INC
WY-964
Data bus: | 16-bit, ISA |
Size: | Half-length, full-height card |
Hard drive supported: | Two IDE (AT) Interface drives |
Floppy drives supported: | Two 360KB, 720KB, 1.2MB, or 1.44MB drives |
CONNECTIONS | |
Function | Location |
40-pin IDE(AT) Interface connector | CN1 |
34-pin control cable connector - floppy drive | CN2 |
10-pin serial port (COM2/4) - internal | CN3 |
10-pin serial port (COM1/3) - external | CN4 |
25-pin parallel port (LPT1/2) - external | CN5 |
4-pin connector - Drive active LED | JP1 |
USER CONFIGURABLE SETTINGS | |||
Function | Location | Setting | |
| » | Index address 398, Data address 399 enabled | JP7 | pins 1 & 2 closed |
Index address 26E, Data address 26F enabled | JP7 | pins 2 & 3 closed | |
MISCELLANEOUS TECHNICAL NOTES |
Jumpers JP2, JP3, JP4, JP5, JP6, JP9, and JP11 are factory configured to pins 1 & 2 closed; JP8 and JP10 are factory configured to pins 2 & 3 closed - do not alter. |
My Books
