ULTRA22C Hard Disk/Floppy Controller Settings and Configuration
ULTRASTOR CORPORATION
ULTRA22C
Data bus: 32 bit, EISA
Size: Full-length, half-height card
Hard drives supported: Two ESDI drives
Floppy drives supported: Two 360KB, 720KB, 1.2MB, or 1.44MB
Maximum heads/cyl.: 16 heads and 1024 cylinders
The two expansion board connectors (along the top and bottom) are not depicted in this illustration.
CONNECTIONS | |
Function | Location |
20-pin data cable connector-drive 0 | J1 |
20-pin data cable connector-drive 1 | J2 |
34-pin control cable connector-hard drive | J3 |
4-pin connector-drive active LED | J4 |
FACTORY CONFIGURED SETTINGS ALL JUMPERS ON THE 22C ARE FOR FACTORY USE AND SHOULD REMAIN AT THE FACTORY DEFAULT SETTINGS. | |||
Function | Location | Setting | |
| » | Factory configured - do not alter | JP1 | closed |
| » | Factory configured - do not alter | JP3 | open |
| » | Factory configured - do not alter | JP4/jumper 1 | closed |
| » | Factory configured - do not alter | JP4/jumpers 2 -5 | open |
| » | Factory configured - do not alter | JP4/jumper 6 | closed |
| » | Factory configured - do not alter | JP4/jumper 7 & 8 | open |
| » | Factory configured - do not alter | JP4/jumper 9 | closed |
| » | Factory configured - do not alter | JP4/jumper 10 | open |
| » | Factory configured - do not alter | JP5/jumper 1 | open |
| » | Factory configured - do not alter | JP5/jumper 2 | closed |
| » | Factory configured - do not alter | JP6/jumper 1 | open |
| » | Factory configured - do not alter | JP6/jumper 2 | closed |
My Books
