TIE-1200 Hard Disk/Floppy Controller Settings and Configuration

Data bus:	16-bit, ISA
Size:	Full-length, full-height card
Hard drive supported:	Up to seven SCSI devices
Floppy drives supported:	None

CONNECTIONS
Function	Location
4-pin connector - Drive active LED	CN1
4-pin RJ11 Chipcard Reader connector - internal	CN2
50-pin SCSI connector - internal	CN3
4-pin RJ11 Chipcard Reader connector - external	CN4
50-pin SCSI connector - external	CN5

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	I/O port address is 310h	J1/switch 1	on
	I/O port address is 350h	J1/switch 1	off
»	TTL Chipcard Reader enabled	J2/jumpers 1 - 6	pins 1 & 2 closed
	RS-232 Chipcard Reader enabled	J2/jumpers 1 - 6	pins 2 & 3 closed

STATUS LEDS
Status	LED 4	LED 3	LED 2	LED 1
Reset after power on	on	on	on	on
RAM test	on	on	on	off
DES chip test	on	on	off	on
Internal software test	on	on	off	off
TIE-1200 in download mode	on	off	on	on
Download mode (service)	on	off	on	off
Wrong transaction number	on	off	off	on
Download post processing	on	off	off	off
Internal program start	off	on	on	on
Software loaded	off	on	on	off
TIE diagnostic information	off	on	off	on
TIE diagnostic information	off	on	off	off
TIE diagnostic information	off	off	on	on
TIE diagnostic information	off	off	on	off
TIE-1200 installed (blinking LED)	off	off	off	on

MISCELLANEOUS TECHNICAL NOTES

J1/switches 2 - 4 are factory-configured to "on" position - do not alter.