PEL - 1600 SERIES Hard Disk/Floppy Controller Settings and Configuration

Data bus:	16-bit ISA
Size:	Three/quarter-length, full-height card
Hard drive supported:	Up to seven SCSI drives
Floppy drives supported:	Two 360KB, 720KB, 1.2MB, or 1.44MB drives

CONNECTIONS
Function	Location
34-pin cable connector - floppy drive	J1
50-pin SCSI connector - internal	J2
4-pin connector - drive active LED	J3
25-pin parallel port - external	J4

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Factory configured - do not alter	S1/1	off
»	Factory configured - do not alter	S1/2	off
»	Factory configured - do not alter	S1/3	off
»	Factory configured - do not alter	S1/4	off
»	Floppy drive enabled	S1/5	on
	Floppy drive disabled	S1/5	off
»	SCSI termination enabled	S2/7	on
	SCSI termination disabled	S2/7	off
»	Parallel port address is 340h - 350h	S2/8	off
	Parallel port address is 140h - 150h	S2/8	on

BIOS ADDRESS SELECTION
Address	S1/6	S1/7	S1/8
C800h - CBFFh	off	off	off
CC00h - CFFFh	on	off	off
D000h - D3FFh	off	on	off
D400h - D7FFh	on	on	off
D800h - DBFFh	off	off	on
DC00h - DFFFh	on	off	on
Disabled	off	on	on
Disabled	on	on	on

INTERRUPT SELECTION
IRQ		S2/1	S2/2	S2/3	S2/4	S2/5	S2/6
»	11	off	off	on	off	off	off
	5	on	off	off	off	off	off
	10	off	on	off	off	off	off
	12	off	off	off	on	off	off
	14	off	off	off	off	on	off
	15	off	off	off	off	off	on