PEL - 800 SERIES Hard Disk/Floppy Controller Settings and Configuration
PRACTICAL ENHANCED LOGIC, CORP.
PEL - 800 SERIES
Data bus: | 8-bit ISA |
Size: | Half-length, full-height card |
Hard drive supported: | Up to seven SCSI drives |
Floppy drives supported: | NONE |
CONNECTIONS | |
Function | Location |
50-pin SCSI connector - internal | J1 |
25-pin SCSI connector - external | J2 |
4-pin connector - drive active LED | J3 |
USER CONFIGURABLE SETTINGS | |||
| Function | Location | Setting | |
| » | Memory mapped mode | S1/4 | off |
| PIO memory mode | S1/4 | on | |
| » | Zero waite state enabled | S1/5 | on |
| Zero waite state disabled | S1/5 | off | |
| » | SCSI termination enabled | S1/6 | on |
| SCSI termination disabled | S1/6 | off | |
| » | IRQ3 disabled | S1/7 | off |
| IRQ3 enabled | S1/7 | on | |
| » | IRQ5 disabled | S1/8 | off |
| IRQ5 enabled | S1/8 | on | |
Note: IRQ3 & IRQ5 are in the off position and should only be turned on when enabled through the software. | |||
BIOS ADDRESS SELECTION | ||||
BIOS Address | I/O Address | S1/1 | S1/2 | S1/3 |
C800h - CBFFh | 310h - 31Fh | off | off | on |
CC00h - CFFFh | 300h - 30Fh | on | off | on |
D000h - D3FFh | 290h - 29Fh | off | on | on |
D400h - D7FFh | 280h - 29Fh | on | on | on |
D800h - DBFFh | 350h - 35Fh | off | off | off |
DC00h - DFFFh | 348h - 357h | on | off | off |
E000h - E3FFh | 340h - 34Fh | off | on | off |
E400h - E7FFh | 330h - 33Fh | on | on | off |
My Books
