LCS-6622/W Hard Disk/Floppy Controller Settings and Configuration
LONGSHINE MICROSYSTEM, INC.
LCS-6622/W
Data bus: 16-bit, ISA
Size: Full-length, half-height card
Hard drives supported: Two ST506/412 MFM drives
Floppy drives supported: Two 360KB, 720KB, 1.2MB, or 1.44MB drives
CONNECTIONS | |
Function | Location |
4-pin connector-drive active LED | CN1 |
20-pin data cable connector-drive 1 | CN2 |
20-pin data cable connector-drive 0 | CN3 |
34-pin control cable connector-hard drives | CN4 |
34-pin data cable connector-floppy drives | CN5 |
USER CONFIGURABLE SETTINGS | |||
Function | Location | Setting | |
| » | Floppy drive port address is 3F0-3F7h | JP1 | open |
| Floppy drive port address is 370-377h | JP1 | closed | |
| » | Hard drive port address is 1F0-1F7h | JP2 | open |
Hard drive port address is 170-177h | JP2 | closed | |
| » | LCS-6622/W not grounded to host | JP3 | open |
LCS-6622/W grounded to host | JP3 | closed | |
| » | LED is always lit (Latch mode) | JP6/jumper 1 | open |
LED lit only when drive is selected (Non-latch mode) | JP6/jumper 1 | closed | |
| » | Four Byte ECC | JP6/jumper 2 | open |
| » | Not used | JP6/jumper 2 | closed |
| » | Format incompatible with WD1003-WAH | JP6/jumper 3 | open |
Format compatible with WD1003-WAH | JP6/jumper 3 | closed | |
My Books
