WA6-V4 Hard Disk/Floppy Controller Settings and Configuration
KIMPSION INTERNATIONAL
WA6-V4
Q4 /92 |
Data bus: 16-bit, ISA
Size: Full-length, half-height card
Hard drives supported: Two MFM ST506 drives
Floppy drives supported: Four 360KB, 720KB, 1.2MB, or 1.44MB
Sector interleave: 1:1
CONNECTIONS | |
Function | Location |
4-pin connector-drive active LED | CN1 |
20-pin data cable connector-drive 1 | CN2 |
20-pin data cable connector-drive 0 | CN3 |
34-pin control cable connector-hard drive | CN4 |
34-pin data cable connector-floppy drives 0 and 1 | CN7 |
34-pin data cable connector-floppy drives 2 and 3 | CN8 |
USER CONFIGURABLE SETTINGS | |||
Function | Location | Setting | |
| » | Hard drive port address is 1F0-1F7h | JP5 | pins 2 & 3 closed |
| Hard drive port address is 170-177h | JP5 | pins 1 & 2 closed | |
| » | Floppy drive port address for CN7 is 3F0-3F7h | JP6 | pins 2 & 3 closed |
| Floppy drive port address for CN7 is 370-377h | JP6 | pins 1 & 2 closed | |
| » | Bracket ground option disabled | JP9 | open |
Bracket ground option enabled | JP9 | closed | |
| » | Floppy drive port address for CN8 is 370-377h | JP10 | closed |
| Floppy drive port address for CN8 is 3F0-3F7h | JP10 | open | |
DRIVE SELECT MODE JUMPERS | ||
Drive Size | Switch 1, 3, 5 or 7 | Switch 2, 4, 6, or 8 |
360KB | on | on |
720KB | on | off |
1.2KB | off | on |
1.44KB | off | off |
Floppy drive 0 uses SW1/switches 1 and 2 Floppy drive 1 uses SW1/switches 3 and 4 Floppy drive 2 uses SW1/switches 5 and 6 Floppy drive 3 uses SW1/switches 7 and 8 | ||
My Books
