Three-quarter length, full-height card
Hard drive supported:
Up to seven Fast SCSI-2 devices, up to fifteen Fast and Wide SCSI-3 devices
Floppy drives supported:
Two 360KB, 720KB, 1.2MB, 1.44MB, or 2.88MB drives
34-pin cable connector - floppy drive
4-pin connector - drive active LED
50-pin SCSI connector - internal
50-pin SCSI connector - external
68-pin SCSI connector - internal
USER CONFIGURABLE SETTINGS
Floppy drive interface enabled as primary
Pins 2 & 3 closed
Floppy drive interface disabled
Pins 1 & 2 closed
Normally configure board during installation
Lock configuration during installation
Note: SW1 is set to normal unless two ISApport boards are installed on the same system. In this
situation, the boards are installed sequentially. First, board 1 is installed and configured. Then,
its SW1 is set to lock, and board 2 is installed and configured with its SW1 set to normal.
The reset setting for SW1 is unidentified.
MISCELLANEOUS TECHNICAL NOTES
VESApport can only be configured with devices chained off two SCSI connectors (e.g. J5 and J6, J5 and J10, or J6 and J10). The board does not work when devices are chained off all three connectors.