ISAPPORT Hard Disk/Floppy Controller Settings and Configuration

ACCULOGIC, INC.

ISAPPORT

Data bus:
16-bit ISA
Size:
Half-length, full-height card
Hard drive supported:
Up to seven Fast SCSI-2 devices
Floppy drives supported:
Two 360KB, 720KB, 1.2MB, 1.44MB, or 2.88MB drives

CONNECTIONS
Function
Location
50-pin SCSI connector - external
J1
50-pin SCSI connector - internal
J2
34-pin cable connector - floppy drive
J3
4-pin power connector
J8
4-pin connector - drive active LED
J9

USER CONFIGURABLE SETTINGS
Function
Location
Setting
»
Floppy drive interface enabled as primary
JP2
Pins 2 & 3 closed

Floppy drive interface disabled
JP2
Pins 1 & 2 closed
»
Normally configure board during installation
SW1
Position 2

Lock configuration during installation
SW1
Position 1

Reset configuration
SW1
Position 3
Note: SW1 is set to normal unless two ISApport boards are installed on the same system. In this
situation, the boards are installed sequentially. First, board 1 is installed and configured. Then,
its SW1 is set to lock, and board 2 is installed and configured with its SW1 set to normal.
The reset setting for SW1 is not identified.

Headaches Begone! A Systemic Approach To Healing Your Headaches

Don't Let Your Bike Seat Ruin Your Sex Life Book

ISAPPORT Hard Disk/Floppy Controller Settings and Configuration

Search

My Books

Discover


Data bus:	16-bit ISA
Size:	Half-length, full-height card
Hard drive supported:	Up to seven Fast SCSI-2 devices
Floppy drives supported:	Two 360KB, 720KB, 1.2MB, 1.44MB, or 2.88MB drives

CONNECTIONS
Function	Location
50-pin SCSI connector - external	J1
50-pin SCSI connector - internal	J2
34-pin cable connector - floppy drive	J3
4-pin power connector	J8
4-pin connector - drive active LED	J9

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Floppy drive interface enabled as primary	JP2	Pins 2 & 3 closed
	Floppy drive interface disabled	JP2	Pins 1 & 2 closed
»	Normally configure board during installation	SW1	Position 2
	Lock configuration during installation	SW1	Position 1
	Reset configuration	SW1	Position 3
Note: SW1 is set to normal unless two ISApport boards are installed on the same system. In this situation, the boards are installed sequentially. First, board 1 is installed and configured. Then, its SW1 is set to lock, and board 2 is installed and configured with its SW1 set to normal. The reset setting for SW1 is not identified.