SIDE-2 Hard Disk/Floppy Controller Settings and Configuration
ACCULOGIC, INC.
SIDE-2
DATA BUS: | 16-BIT, ISA | ||
Size: | Half-length, half-height card | ||
Hard drives supported: | Two IDE(AT) drives | ||
Floppy drives supported: | None | ||
CONNECTIONS | |
Function | Location |
4-pin connector-Drive Active LED | J1 |
40-pin XT Interface (IDE) connector | J2 |
USER CONFIGURABLE SETTINGS | |||
Function | Location | Setting | |
| » | Hard drive port address is 1F0-1F7h | JP7 | open |
Hard drive port address is 170-177h | JP7 | closed | |
| » | I/O Channel Ready signal disabled | JP10 | open |
I/O Channel Ready signal enabled | JP10 | closed | |
IRQ14 STATUS | |||
Function | Jumper JP1 | Jumper JP2 | |
| » | IRQ14 normal | closed | open |
IRQ14 delayed until ACTIVE- signal is removed | open | closed | |
MISCELLANEOUS TECHNICAL NOTES |
JP3 through JP6, and JP8 & JP9 are Not used. |
My Books
