SIDE-1 Hard Disk/Floppy Controller Settings and Configuration
ACCULOGIC, INC.
SIDE-1
Data bus: | 8-bit, ISA |
Size: | Half-length, full-height card |
Hard drives supported: | One IDE(XT) drive |
Floppy drives supported: | None |
CONNECTIONS | |
Function | Location |
40-pin XT Interface (IDE) connector | J2A |
5-pin connector-DC power | J4 |
USER CONFIGURABLE SETTINGS | |||
Function | Location | Setting | |
| » | BIOS address is C800h | W1 | pins 2 & 3 closed |
BIOS address is CA00h | W1 | pins 1 & 2 closed | |
| » | I/O port address is 320h | W2 | pins 1 & 2 closed |
I/O port address is 324h | W2 | pins 2 & 3 closed | |
| » | Interrupt Request is IRQ5 | W3 | pins 1 & 2 closed |
Interrupt Request is IRQ2* | W3 | pins 2 & 3 closed | |
BIOS SUPPORTED CONFIGURATIONS | ||
Formatted Capacity | Maximum Heads | Cylinders |
20 MB | 2 | 782 |
30 MB | 3 | 782 |
40 MB | 4 | 782 |
MISCELLANEOUS TECHNICAL NOTES |
This controller has an on-board low-level format program. To enter the program, run DEBUG utility supplied with DOS and enter G=C800:5 at the prompt. This controller supports 17 SPT translation. *If IRQ2 is selected the drive must also be set to IRQ2 (See Volume 2: Drive Settings) |
My Books
