VGA-V (52100T) video card Settings and Configuration
AUVA COMPUTER, INC.
VGA-V (52100T)
Card Type | Video card |
Video Chip Set | Tseng Labs |
Highest Resolution Supported | 1024 x 768 |
Maximum Video Memory | 1MB DRAM |
Data Bus | 8/16-bit ISA |
Video Types Supported | Monochrome, CGA, EGA, VGA |
CONNECTIONS | |||
Function | Label | Function | Label |
Feature connector | CN1 | 15-pin analog video port | CN2 |
USER CONFIGURABLE SETTINGS | |||
Function | Label | Position | |
| » | IRQ 2/9 disabled | J1 | Pins 2 & 3 closed |
IRQ 2/9 enabled | J1 | Pins 1 & 2 closed | |
| » | Scan rate >48.7KHz (non-interlaced mode) | SW3 | Open |
Scan rate <48.7KHz (interlaced mode) | SW3 | Closed | |
| » | Autodetect enabled | SW4 | Open |
Autodetect disabled | SW4 | Closed | |
DRAM CONFIGURATION |
Note: 256KB, 512 KB, or 1MB DRAM configurations available. The orientation of the banks and size of chips used are unidentified. |
MONITOR DETECTION CONTROL | ||
Function | J6 | |
| » | IBM standard monitor pinout | Pins 1 & 2 closed |
Non-standard color pinout | Open | |
Non-standard monochrome pinout | Pins 2 & 3 closed | |
Note: If your VGA monitor boots up in monochrome mode remove the jumper, and if your VGA monochrome monitor does not display correctly place the jumper over pins 2 & 3. | ||
My Books
