lotus

previous page: WANGTEK 5525ES (33711-XXX) Tape drive card Settings and Configuration
  
page up: Tape Drives Specs
  
next page: WANGTEK 5525ES (VER. 2) Tape drive card Settings and Configuration

WANGTEK 5525ES (33959-XXX) Tape drive card Settings and Configuration






TECMAR

WANGTEK 5525ES (33959-XXX)

Device Type

Internal Tape Drive

Interface

SCSI-1, SCSI-2

Format

QIC-120, QIC-150, or QIC525 (write)

QIC-24, QIC-120, QIC-150, or QIC-525 (read)

Sustained Transfer Rate

200 KBPS

Size

5.25 in. half height

View

Bottom

CONNECTIONS

Function

Label

Chassis ground connector

W1

USER CONFIGURABLE SETTINGS

Setting

Label

Position

Factory configured - do not alter (Built in test mode(s))

E2

Open

Factory configured - do not alter

E3

Unidentified

Factory configured - do not alter (Built in test mode(s))

E4

Open

Factory configured - do not alter (48 MHz main oscillator enabled)

E5

Closed

1024 byte block mode enabled

JP2

Open

 

512 byte block mode enabled

JP2

Closed

Factory configured - do not alter (Built in test mode(s))

JP3

Open

Factory configured - do not alter (Built in test mode(s))

JP6

Open

Factory configured - do not alter

JP7

Unidentified

Factory configured - do not alter

JP8

Unidentified

Factory configured - do not alter

JP9

All pins open

Factory configured - do not alter (Built in test mode(s))

JP12

Open

Factory configured - do not alter (Diagnostic test connector)

JP32

Open

DRIVE SELECT ID

Drive ID

JP1/A

JP1/B

JP1/C

0

Open

Open

Open

 

1

Closed

Open

Open

 

2

Open

Closed

Open

 

3

Closed

Closed

Open

 

4

Open

Open

Closed

 

5

Closed

Open

Closed

 

6

Open

Closed

Closed

 

7

Closed

Closed

Closed

Note: Jumper JP1/D is factory configured and should not be altered. The default position for JP1/D is Open.

TERMINATION POWER SELECTION

Setting

E1

TERMPWR supplied by drive

Closed

 

TERMPWR supplied by SCSI interface to drive

Open

Note: The fuse at F1 must be installed when TERMPWR is supplied by the drive.

MISCELLANEOUS TECHNICAL NOTES

Termination is enabled or disabled via the three removable terminating resistors (see diagram).








TOP
previous page: WANGTEK 5525ES (33711-XXX) Tape drive card Settings and Configuration
  
page up: Tape Drives Specs
  
next page: WANGTEK 5525ES (VER. 2) Tape drive card Settings and Configuration