V-LINK/2 (VP-892) Sound card Settings and Configuration
ELETECH ENTERPRISE CO., LTD.
V-LINK/2 (VP-892)
Card Type | Voice card |
Chip Set | Unidentified |
Maximum Onboard Memory | N/A |
I/O Options | Line1, line 2, microphone in, tape in, speaker out |
Hard Drives supported | None |
Floppy drives supported | None |
Data Bus | 16-bit ISA |
Card Size | Three-quarter-length, full-height |
CONNECTIONS | |||
Function | Label | Function | Label |
Line 2 | CN1 | Speaker out | CN5 |
Line 1 | CN2 | Unidentified | SENS |
Microphone in | CN3 | Volume | VOL |
Tape in | CN4 | ||
USER CONFIGURABLE SETTINGS | |||
Function | Label | Position | |
| » | Factory configured - do not alter | W11 | Unidentified |
| » | Factory configured - do not alter | W12 | Unidentified |
| » | Factory configured - do not alter | W13 | Unidentified |
| » | Factory configured - do not alter | W14 | Unidentified |
| » | Factory configured - do not alter | W19 | Unidentified |
| » | Factory configured - do not alter | W20 | Unidentified |
| » | 1/2 make/break ratio for pulse dialing on line 1 enabled | W21 | Closed |
2/3 make/break ratio for pulse dialing on line 1 enabled | W21 | Open | |
| » | 1/2 make/break ratio for pulse dialing on line 2 enabled | W22 | Closed |
2/3 make/break ratio for pulse dialing on line 2 enabled | W22 | Open | |
MICROPHONE /TAPE INPUT SELECTION | ||
Setting | W1 | W2 |
Line 1 | Closed | Open |
Line 2 | Open | Closed |
SPEAKER OUTPUT SELECTION | |||
Setting | W3 | W4 | |
| » | Line 1 | Closed | Open |
Line 2 | Open | Closed | |
Note:This option is usually set according to microphone/tape input selection since the speaker is usually used to monitor the recording of messages from a tape player. | |||
LINE 1 BASE I/O ADDRESS AND INTERRUPT SELECTION | |||
IRQ | I/O Address | W15 | W16 |
2 | 238h | Closed | Closed |
3 | 270h | Open | Closed |
5 | 230h | Closed | Open |
7 | 278h | Open | Open |
LINE 2 BASE I/O ADDRESS AND INTERRUPT SELECTION | |||
IRQ | I/O Address | W17 | W18 |
10 | 310h | Closed | Closed |
11 | 318h | Closed | Open |
12 | 320h | Open | Closed |
15 | 328h | Open | Open |
LINE 1 TELEPHONE INPUT AMPLIFICATION SELECTION | ||||
Setting | W5 | W6 | W7 | |
| » | Low | Closed | Open | Open |
Medium | Open | Closed | Open | |
High | Open | Open | Closed | |
LINE 2 TELEPHONE INPUT AMPLIFICATION SELECTION | ||||
Setting | W8 | W9 | W10 | |
| » | Low | Closed | Open | Open |
Medium | Open | Closed | Open | |
High | Open | Open | Closed | |
DIAGNOSTIC LED(S) | ||
LED | Status | Condition |
L1 | On | Hookswitch of line 1 is off-hook |
L1 | Off | Hookswitch of line 1 is on-hook |
L2 | On | Hookswitch of line 2 is off-hook |
L2 | Off | Hookswitch of line 2 is on-hook |
VR1, VR2, VR3 SELECTION | ||
Label | Status | Condition |
VR1 | Turn clockwise | Amplify microphone input signal |
VR2 | Turn clockwise | Increase speaker output volume |
VR3 | 12 to 64 Kbps adjustable range | Sampling rate selection |
Note:Location of VR1, VR2 and VR3 is unidentified. Default for VR3 is 32 Kbps. | ||
My Books
