PRONIC LAN10MB/LAN10MT/LAN10MM Network Card Settings and Configuration
ZENITH DATA SYSTEMS
PRONIC LAN10MB/LAN10MT/LAN10MM
NIC Type | Ethernet |
Transfer Rate | 10Mbps |
Data Bus | 8-bit ISA/16-bit ISA |
Topology | Linear bus Star |
Wiring Type | Unshielded twisted pair (LAN10MT, LAN10MM) RG58A/U 50ohm coaxial (LAN10MB, LAN10MM) AUI transceiver via DB15 (LAN10MB, LAN10MT, LAN10MM) |
Boot ROM | Available |
INTERRUPT, BASE I/O ADDRESS, BOOT ROM MEMORY | |||||||
IRQ | Base I/O | I/O Type | ROM Addr | ROM Size | JU1 | JU2 | ROT |
3 | 300h | I/O | C800 | 16KB | Pins 2 & 3 | N/A | 0 |
3 | 280h | Shared Mem | C800 | 16KB | Pins 2 & 3 | N/A | 4 |
4 | 360h | I/O | D000 | 32KB | N/A | N/A | 1 |
4 | 340h | Shared Mem | D000 | 32KB | N/A | N/A | 5 |
5 | 280h | I/O | CC00 | 16KB | N/A | Pins 2 & 3 | 2 |
5 | 300h | Shared Mem | CC00 | 16KB | N/A | Pins 2 & 3 | 6 |
9 | 240h | I/O | D800 | 32KB | N/A | N/A | 3 |
9 | 240h | Shared Mem | D800 | 32KB | N/A | N/A | 7 |
10 | 300h | I/O | C800 | 16KB | Pins 1 & 2 | N/A | 0 |
10 | 280h | Memory | C800 | 16KB | Pins 1 & 2 | N/A | 4 |
11 | 280h | I/O | CC00 | 16KB | N/A | Pins 1 & 2 | 2 |
11 | 300h | Shared Mem | CC00 | 16KB | N/A | Pins 1 & 2 | 6 |
Software | Software | Software | Software | Software | N/A | N/A | 8 |
Software | Software | Software | Software | Software | N/A | N/A | 9 |
Note:Rotary switch positions 8 and 9 are configured using setup software. Configuration options are retained by the card until changed. Pins designated should be in the closed position. | |||||||
BOOT ROM | |
Mode | SW1/1 |
Enabled | On |
Disabled | Off |
CONFIGURATION LOCK | |
Function | SW1/2 |
Software configuration write enabled | Off |
Software configuration write disabled | On |
CABLE TYPE | ||
Setting | SW1/3 | SW1/4 |
Unshielded twisted pair (185 ft) | Off | Off |
AUI transceiver via DB15 | Off | On |
RG58A/U 50ohm coaxial | On | Off |
Unshielded twisted pair (300 ft) | On | On |
My Books
