16-BIT ETHERNET ADAPTER Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	16-bit ISA
Topology	Star
Wiring Type	Unshielded twisted pair AUI transceiver via DB-15 port
Boot ROM	Available

COMPATIBILITY MODE
Setting		JP1
»	Disabled	Pins 1 & 2 closed
	Enabled	Pins 2 & 3 closed
Note:On some systems the data bus timing is not truly IBM PC/AT compatible. If the card is not initializing enabling compatibility mode may allow the card to operate properly.

I/O BASE ADDRESS
Address		JP2A	JP2B	JP2C
	200 - 21Fh	Open	Closed	Closed
	220 - 23Fh	Open	Closed	Open
	240 - 25Fh	Open	Open	Closed
	260 - 27Fh	Open	Open	Open
	300 - 31Fh	Closed	Closed	Closed
	320 - 33Fh	Closed	Closed	Open
»	340 -35Fh	Closed	Open	Closed
	360 - 37Fh	Closed	Open	Open

INTERRUPT REQUEST
IRQ		JP3A	JP3B	JP3C	JP3D	JP3E	JP3F
	2/9	Open	Open	Open	Open	Open	Closed
»	3	Closed	Open	Open	Open	Open	Open
	4	Open	Closed	Open	Open	Open	Open
	5	Open	Open	Closed	Open	Open	Open
	6	Open	Open	Open	Closed	Open	Open
	7	Open	Open	Open	Open	Closed	Open

BOOT ROM ADDRESS
Address		JP4A	JP4B	JP4C
	C0000 - C3FFFh	Closed	Closed	Closed
	C4000 - C7FFFh	Closed	Closed	Open
	C8000 - CBFFFh	Closed	Open	Closed
	CC000 - CFFFFh	Closed	Open	Open
»	D0000 - D3FFFh	Open	Closed	Closed
	D4000 - D7FFFh	Open	Closed	Open
	D8000 - DBFFFh	Open	Open	Closed
	DC000 - DFFFFh	Open	Open	Open

BOOT ROM
Setting		JP5
»	Disabled	Pins 2 & 3 closed
	Enabled	Pins 1 & 2 closed

CABLE TYPE
Type		JP6
»	Unshielded twisted pair	Pins 2 & 3 closed
	AUI transceiver via DB-15 port	Pins 1 & 2 closed

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
LED1	Red	On	Data is being received
LED1	Red	Off	Data is not being received
LED2	Green	On	Data is being transmitted
LED2	Green	Off	Data is not being transmitted
LED3	Yellow	On	Twisted pair network connection is good
LED3	Yellow	Off	Twisted pair network connection is broken
LED4	Orange	On	Receive wire polarity reversed
LED4	Orange	Off	Receive wire polarity normal