NIUPC/EOTP Network Card Settings and Configuration
UNGERMANN-BASS NETWORKS, INC.
NIUPC/EOTP
NIC Type | Ethernet |
Transfer Rate | 10Mbps |
Data Bus | 8-bit ISA/16-bit ISA |
Topology | Linear bus |
Wiring Type | Unshielded twisted pair AUI transceiver via DB15 DIX transceiver via DB15 |
Boot ROM | Available |
FACTORY CONFIGURED SETTINGS | |
Jumper | Setting |
JP1A | Closed |
JP1B | Closed |
JP2C | Closed |
JP2D | Open |
JP3A | Open |
JP3B | Open |
BOOT ROM | ||
Setting | JP2C | JP2D |
Disabled | Open | Open |
Enabled with prompt | Open | Closed |
Enabled without prompt | Closed | Closed |
LINK INTEGRITY | ||
Function | JP4A | |
» | Link integrity enabled | Open |
| Link integrity disabled | Closed |
Note: If card is used in a pre-10BaseT cabling network, disable the link integrity function. | ||
BOOT ROM ADDRESS | ||
Address | JP4B | |
» | C0000h | Open |
| D0000h | Closed |
BASE I/O ADDRESS | |||
Address | JP4C | JP4D | |
| 350h | Closed | closed |
| 358h | Open | Closed |
| 360h | Closed | Open |
» | 368h | Open | Open |
DATA BUS | ||
Mode | JP4E | JP4F |
16-bit/8-bit auto detect | Closed | Closed |
Force 8-bit data bus | Open | Open |
SEGMENT LENGTH | |
Length | JP5 |
< 100 meters to hub | Open |
> 100 meters to hub | Closed |
Note:A distance of more than 100 meters between the adapter and hub is not 10BaseT compliant. | |
DB15 MODE CONFIGURATION | ||
Setting | Ground Type | JP6 |
DB15 operates as an AUI port | Logic | Pins 1 & 2 closed |
DB15 operates as a DIX port | Chassis | Pins 2 & 3 closed |
CABLE TYPE | |
Mode | JP7 |
Auto-switch between 10BaseT and DB15 |
|
Force card to use 10BaseT |
|
Force card to use DB15 port |
|
DIAGNOSTIC LED(S) | ||
LED | Status | Condition |
L1 | On | 10BaseT link integrity exists |
L1 | Off | 10BaseT link integrity broken |
My Books
