E-TBT-CHB-2012-M/E-TBT-CHB-2012-S Network Card Settings and Configuration

TRANSITION ENGINEERING, INC.

E-TBT-CHB-2012-M/E-TBT-CHB-2012-S

NIC Type:
Ethernet
Transfer Rate:
10Mbps
Data Bus:
16-bit ISA
Topology:
Star
Wiring Type
AUI transceiver via 50-pin port
Boot ROM
Not available

INTERRUPT SELECTION
Setting
J1
»
IRQ is software configured
Pins 2 & 3 closed

IRQ5
Pins 1 & 2 closed

CARD NUMBER
Card Number
SW1/1
SW1/2
SW1/3
SW1/4
»
#0
On
On
On
On

#1
On
On
On
Off

#2
On
On
Off
On

#3
On
On
Off
Off

#4
On
Off
On
On

#5
On
Off
On
Off

#6
On
Off
Off
On

#7
On
Off
Off
Off

Note (1):SW1 is not installed on the HubServer card. The default setting for the HubServer card is #0.
Note (2):The default setting for Expansion Hub cards is #1. If no HubServer card is used, the first Expansion Hub card should be set to #0. All daisy-chained Expansion Hub cards must be sequentially numbered starting at #1.

CONNECTORS
Purpose
Location
Expansion card daisy-chain connector
CN6
Expansion card daisy-chain connector
CN7
Note (1):The first card of a cluster, usually the HubServer card, must have a termination plug installed on CN7.
Note (2):The last card of a cluster must have a termination plug installed on CN6.

Headaches Begone! A Systemic Approach To Healing Your Headaches

Don't Let Your Bike Seat Ruin Your Sex Life Book

E-TBT-CHB-2012-M/E-TBT-CHB-2012-S Network Card Settings and Configuration

Search

My Books

Discover

NIC Type:	Ethernet
Transfer Rate:	10Mbps
Data Bus:	16-bit ISA
Topology:	Star
Wiring Type	AUI transceiver via 50-pin port
Boot ROM	Not available

INTERRUPT SELECTION
Setting		J1
»	IRQ is software configured	Pins 2 & 3 closed
	IRQ5	Pins 1 & 2 closed

CARD NUMBER
Card Number		SW1/1	SW1/2	SW1/3	SW1/4
»	#0	On	On	On	On
	#1	On	On	On	Off
	#2	On	On	Off	On
	#3	On	On	Off	Off
	#4	On	Off	On	On
	#5	On	Off	On	Off
	#6	On	Off	Off	On
	#7	On	Off	Off	Off
	Note (1):SW1 is not installed on the HubServer card. The default setting for the HubServer card is #0. Note (2):The default setting for Expansion Hub cards is #1. If no HubServer card is used, the first Expansion Hub card should be set to #0. All daisy-chained Expansion Hub cards must be sequentially numbered starting at #1.

CONNECTORS
Purpose	Location
Expansion card daisy-chain connector	CN6
Expansion card daisy-chain connector	CN7
Note (1):The first card of a cluster, usually the HubServer card, must have a termination plug installed on CN7. Note (2):The last card of a cluster must have a termination plug installed on CN6.