PDI7023-16T Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	16-bit ISA
Topology	Star
Wiring Type	Unshielded twisted pair
Boot ROM	Not available

INTERRUPT REQUEST
IRQ		E2A	E2B	E2C	E2D	E2E	E2F	E2G	E2H	E2I	E2J
	2/9	Open	Open	Open	Open	Closed	Open	Open	Open	Open	Open
	3	Open	Open	Open	Open	Open	Open	Open	Open	Open	Closed
»	4	Open	Open	Open	Open	Open	Open	Open	Open	Closed	Open
	5	Open	Open	Open	Open	Open	Open	Open	Closed	Open	Open
	6	Open	Open	Open	Open	Open	Open	Closed	Open	Open	Open
	7	Open	Open	Open	Open	Open	Closed	Open	Open	Open	Open
	10	Open	Open	Open	Closed	Open	Open	Open	Open	Open	Open
	11	Open	Open	Closed	Open	Open	Open	Open	Open	Open	Open
	12	Open	Closed	Open	Open	Open	Open	Open	Open	Open	Open
	15	Closed	Open	Open	Open	Open	Open	Open	Open	Open	Open

I/O BASE ADDRESS
Address		SW1/1	SW1/2	SW1/3
	260h	On	On	On
	290h	Off	On	On
	2E0h	On	Off	On
	2F0h	Off	Off	On
»	300h	On	On	Off
	350h	Off	On	Off
	380h	On	Off	Off
	3E0h	Off	Off	Off

EXTENDED TRANSMIT TIMEOUT
Setting		SW1/5
»	Enabled	On
	Disabled	Off
Note:With this option enabled, if the card is transmitting for an extented amount of time the transmission will be interrupted and continued after a preset time. This keeps the card from dominating the network.

LINK INTEGRITY TEST
Setting		SW1/7
»	Enabled	On
	Disabled	Off

FACTORY CONFIGURED SETTINGS
Switch	Setting
SW1/4	Off
SW1/6	On
SW1/8	Off

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
LED1	Red	On	Card is being accessed by host computer
LED1	Red	Off	Card is not being accessed by host computer
LED2	Green	On	Data is being transmitted or received
LED2	Green	Off	Data is not being transmitted or received
LED3	Red	On	Receive wires are reversed and corrected for
LED3	Red	Off	Normal operation
LED4	Green	On	Network connection is good
LED4	Green	Off	Network connection is broken
Note:If LED3 is lit the receive wires are reversed. The card will automatically correct for this but the wires should be repaired as soon as possible.