PD1516PLUS Network Card Settings and Configuration
PURE DATA LTD.
PD1516PLUS
NIC Type | ARCnet |
Transfer Rate | 2.5Mbps |
Data Bus | 16-bit ISA |
Topology | Linear Bus |
Wiring Type | RG-62A/U 93ohm coaxial |
Boot ROM | Available |
CONFIGURATION MEMORY CLEAR | ||
Clear | JP1 | |
| » | Normal operation | Open |
Clear all addresses and settings from memory | Closed | |
CARDS INSTALLED | ||||
Card number | JP2A | JP2B | JP2C | JP2D |
1 | Closed | Open | Open | Open |
2 | Open | Closed | Open | Open |
3 | Open | Open | Closed | Open |
4 | Open | Open | Open | Closed |
Note:If there is only one NIC installed in a system, set this option to the "1" position. If this NIC is the second NIC to be installed in a system, set this option to the "2" position and so on. | ||||
COMPATIBILITY MODE | ||
Condition | JP3 | |
| » | Compatibility mode disabled | Open |
Compatibility mode enabled | Closed | |
Note: Compatibility mode should be enabled when the NIC is installed in a system using a Suntac 286 chipset. | ||
DIAGNOSTIC LED(S) | |||
LED | Color | Status | Condition |
LED1 | Red | Blinking | I/O bus activity |
LED1 | Red | Off | No I/O bus activity |
LED2 | Green | On | Data is being transmitted or received |
LED2 | Green | Blinking | No network activity detected, or bad connection |
My Books
