MEGANET STATION BOARD Network Card Settings and Configuration

NIC Type	Device Network Architecture (DNA)
Transfer Rate	10Mbps
Data Bus	8-bit ISA
Topology	Linear bus
Wiring Type	Shielded twisted pair Unshielded twisted pair (1 male, 1 female DB-9 connector)
Boot ROM	Available (Permanently installed)

I/O BASE ADDRESS
Address		JP1A	JP1B
»	2E0h	Open	Open
	2E8h	Open	Closed
	3E0h	Closed	Open
	3E8h	Closed	Closed

INTERRUPT REQUEST
IRQ		JP2A	JP2B	JP2C	JP2D
	2	Closed	Open	Open	Open
	3	Open	Closed	Open	Open
	4	Open	Open	Closed	Open
»	5	Open	Open	Open	Closed
	Disabled	Pins one of JP2A & JP2B closed

REMOTE BOOT
Setting		JP4
»	Disabled	Pins 1 & 2 closed
	Enabled	Pins 2 & 3 closed
Note:With remote boot enabled the card will boot from the Meganet Master Board instead of a local drive.

SLOT EIGHT ENABLE
Setting		JP8
»	Disabled	Closed
	Enabled	Open
Note:If the card is installed in slot 8 of an IBM XT or compatible this option must be enabled.