NX 300FO Network Card Settings and Configuration

Card Type	Ethernet Transceiver
NIC Type	Ethernet
Maximum Onboard Memory	Unidentified
Boot ROM	Not available
Network Transfer Rate	20Mbps
Topology	Star
Wiring Type	AUI transceiver via DB-15 port, Fiber optic cable
Data Bus	External

CONNECTIONS
Function	Label	Function	Label
Fiber ST transmit connector	CN1	AUI connector	CN3
Fiber ST receive connector	CN2

USER CONFIGURABLE SETTINGS
Function	Label	Position
Half duplex mode enabled	SW1	On
Full duplex mode enabled	SW1	Off
SQE disabled	SW2	On
SQE enabled	SW2	Off

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
LED1	Green	On	Unit is receiving power
LED1	Green	Off	Unit is not receiving power
LED2	Red	Blinking	Data is being received
LED2	Red	Off	Data is not being received
LED3	Red	Blinking	Data is being transmitted
LED3	Red	Off	Data is not being transmitted
LED4	Red	On	Network connection is good
LED4	Red	Off	Network connection is broken
LED5	Red	On	Collision detected on network
LED5	Red	Off	No collision detected on network
LED6	Red	On	Jabber detected
LED6	Red	Off	No jabber detected