PTC-1001 SERIES Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	16-bit ISA
Topology	Linear Bus
Wiring Type	Shielded/Unshielded Twisted Pair RG-58A/U 50ohm coaxial
Boot ROM	Available

COMPATIBILITY MODE
Setting		JP1A
»	Disabled	Open
	Enabled	Closed
Note:On some systems the data bus timing is not truly IBM PC/AT compatible. If the card is not

BOOT ROM
Setting		JP1B
»	Disabled	Open
	Enabled	Closed

BASE MEMORY ADDRESS
Address		JP1C	JP1D	JP1E
	C0000h	Open	Open	Open
	C4000h	Closed	Open	Open
	C8000h	Open	Closed	Open
	CC000h	Closed	Closed	Open
»	D0000h	Open	Open	Closed
	D4000h	Closed	Open	Closed
	D8000h	Open	Closed	Closed
	DC000h	Closed	Closed	Closed

I/O BASE ADDRESS
I/O		JP1F	JP1G
»	300h	Open	Open
	320h	Open	Closed
	340h	Closed	Open
	360h	Closed	Closed

INTERRUPT REQUEST
IRQ		JP2A	JP2B	JP2C	JP2D	JP2E	JP2F	JP2G	JP2H	JP2I
	2/9	Closed	Open	Open	Open	Open	Open	Open	Open	Open
»	3	Open	Closed	Open	Open	Open	Open	Open	Open	Open
	4	Open	Open	Closed	Open	Open	Open	Open	Open	Open
	5	Open	Open	Open	Closed	Open	Open	Open	Open	Open
	7	Open	Open	Open	Open	Closed	Open	Open	Open	Open
	9	Open	Open	Open	Open	Open	Closed	Open	Open	Open
	10	Open	Open	Open	Open	Open	Open	Closed	Open	Open
	11	Open	Open	Open	Open	Open	Open	Open	Closed	Open
	12	Open	Open	Open	Open	Open	Open	Open	Open	Closed

CABLE TYPE
Type		JP5
»	RG-58A/U 50ohm coaxial	Pins 1 & 2 closed
	Shielded/Unshielded Twisted Pair	Pins 2 & 3 closed
Note:The PTC-1001 BASE 2 model has a RG-58A/U 50ohm coaxial connector only. The PTC-1001 BASE T model has a Shielded/Unshielded Twisted Pair connector only. The PTC-1001 BASE 2/T model (shown in diagram) has both RG-58A/U 50ohm coaxial and Shielded/Unshielded Twisted Pair connectors.