6224 Network Card Settings and Configuration
LANCAST
6224
Card Type | Transceiver |
NIC Type | Ethernet |
Network Transfer Rate | 100Mbps |
Topology | Star |
Wiring Type | RJ-45 jack, Media Independent Interface (MII) |
Data Bus | External |
CONNECTIONS | |||
Function | Label | Function | Label |
40-pin MII interface | CN1 | RJ-45 jack | CN2 |
USER CONFIGURABLE SETTINGS | ||
Function | Label | Position |
Set speed of the unit to 10Mbps | SW1/1 | On |
Set speed of the unit to 100Mbps | SW1/1 | Off |
Half-Duplex mode | SW1/2 | On |
Full-Duplex mode | SW1/2 | Off |
DIAGNOSTIC LED(S) | |||
LED | Color | Status | Condition |
PWR | Unidentified | On | Power is being received from the DTE device |
PWR | Unidentified | Off | Power is not being received from the DTE device |
LNK | Unidentified | On | Link is good |
LNK | Unidentified | Off | Link is broken |
TX | Unidentified | Blinking | Data is being transmitted |
TX | Unidentified | Off | Data is not being transmitted |
RX | Unidentified | Blinking | Data is being received |
RX | Unidentified | Off | Data is not being received |
COL | Unidentified | On | Collision detected on network |
COL | Unidentified | Off | No collision detected on network |
MISCELLANEOUS TECHNICAL NOTES |
SW1/2 - 4 control the PHY settings. The exact configuration information is unavailable. |
My Books
