NIC-2000T (Revision 2) Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	16-bit ISA
Topology	Star
Wiring Type	Unshielded twisted pair AUI transceiver via DB-15 port
Boot ROM	Available

BOOT ROM
Setting		W1
»	Disabled	Open
	Enabled	Closed

CABLE TYPE
Type		W9
»	Unshielded twisted pair	Pins 2 & 3 closed
	AUI transceiver via DB-15 port	Pins 1 & 2 closed

LINK INTEGRITY TEST
Function		W10
»	Link intergity enabled	Pins 1 & 2 closed
	Link integrity disabled	Pins 2 & 3 closed

WAIT STATE SELECTION
1 Wait State		W4
»	Enabled	Open
	Disabled	Closed

INTERRUPT SETTINGS
IRQ		W5	W6	W7	W8	W11	W12	W13	W14
»	IRQ3	Closed	Open	Open	Open	Open	Open	Open	Open
	IRQ4	Open	Closed	Open	Open	Open	Open	Open	Open
	IRQ5	Open	Open	Closed	Open	Open	Open	Open	Open
	IRQ9	Open	Open	Open	Closed	Open	Open	Open	Open
	IRQ10	Open	Open	Open	Open	Closed	Open	Open	Open
	IRQ11	Open	Open	Open	Open	Open	Closed	Open	Open
	IRQ12	Open	Open	Open	Open	Open	Open	Closed	Open
	IRQ15	Open	Open	Open	Open	Open	Open	Open	Closed

I/O BASE ADDRESS AND BOOT ROM ADDRESS
I/O Base Address		Boot ROM Address	W2	W3
»	300h - 31Fh	C800h	Closed	Closed
	320h - 33Fh	CC00h	Open	Closed
	340h - 35Fh	D000h	Closed	Open
	360h - 37Fh	D400h	Open	Open

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
LED1	Yellow	On	Data is not being transmitted
LED1	Yellow	Blinking	Data is being transmitted
LED2	Red	On	Data is not being received
LED2	Red	Blinking	Data is being received
LED3	Green	On	10BaseT link integrity exists
LED3	Green	Off	10BaseT link integrity test disabled
LED4	Red	Off	Polarity is correct
LED4	Red	On	Polarity is reversed
Note:LED3 is only functional when link integrity is enabled, and when installed on a 10BaseT network.