G/EtherNet 8 Adapter Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	8-bit ISA
Topology	Linear Bus
Wiring Type	RG-58A/U 50ohm coaxial AUI transceiver via DB-15 port
Boot ROM	Available

INTERRUPT REQUEST
IRQ		JP1	JP2	JP3	JP4	JP5	JP6
	2	Closed	Open	Open	Open	Open	Open
»	3	Open	Closed	Open	Open	Open	Open
	4	Open	Open	Closed	Open	Open	Open
	5	Open	Open	Open	Closed	Open	Open
	6	Open	Open	Open	Open	Closed	Open
	7	Open	Open	Open	Open	Open	Closed

I/O BASE ADDRESS
Address		SW1/1	SW1/2	SW1/3	SW1/4
	280-29Fh	On	On	On	On
»	2A0-2BFh	On	Off	On	On
	2C0-2DFh	On	On	Off	On
	2E0-2FFh	On	Off	Off	On
	300-31Fh	On	On	On	Off
	320-33Fh	On	Off	On	Off
	340-35Fh	On	On	Off	Off
	360-37Fh	On	Off	Off	Off

BASE MEMORY ADDRESS
Base Address		SW1/5	SW1/6
	C0000-C3FFF	On	On
	C4000-C7FFF	Off	On
	C8000-CBFFF	On	Off
»	CC000- CFFFF	Off	Off

CABLE TYPE
Type		JP7	JP8	JP9	JP10
»	RG-58A/U 50ohm coaxial	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2
	AUI transceiver via DB-15 port	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3
Note:Pins designated should be in the closed position.

MISCELLANEOUS NOTES

Different drivers must be used for the National & the Fujitsu chipset cards, & are not interchangeable. Fujitsu adapters may be used for either 8 or 16 bit Fujitsu cards. While the National chipset cards require a different driver for an 8 or 16 bit card.