ETHER-T PC ADAPTER Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	8-bit ISA
Topology	Star Linear Bus
Wiring Type	Shielded/Unshielded twisted pair AUI Transceiver via DB-15 port
Boot ROM	Available

INTERRUPT REQUEST
IRQ		JP1	JP2	JP3	JP4	JP5	JP6
	2	Closed	Open	Open	Open	Open	Open
»	3	Open	Closed	Open	Open	Open	Open
	4	Open	Open	Closed	Open	Open	Open
	5	Open	Open	Open	Closed	Open	Open
	6	Open	Open	Open	Open	Closed	Open
	7	Open	Open	Open	Open	Open	Closed

CABLE TYPE
Type		JP7-12
»	Shielded/Unshielded twisted pair	Pins 1 & 2 Closed
	AUI transceiver via DB-15 port	Pins 2 & 3 Closed

BOOT ROM ADDRESS
Address		SW1/5	SW1/6
	C0000-C3FFFh	On	On
	C4000-C7FFFh	Off	On
	C8000-CBFFFh	On	Off
»	CC000-CFFFFh	Off	Off

I/O BASE ADDRESS
I/O Address		SW1/1	SW1/2	SW1/3	SW1/4
	280-29Fh	On	On	On	On
»	2A0-2BFh	On	Off	On	On
	2C0-2DFh	On	On	Off	On
	2E0-2FFh	On	Off	Off	On
	300-31Fh	On	On	On	Off
	320-33Fh	On	Off	On	Off
	340-35Fh	On	On	Off	Off
	360-37Fh	On	Off	Off	Off

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
1	Red	On	The adapter or hub port is malfunctioning.
1	Red	Off	The adapter or hub port is operating normally.
2	Green	On	Good network cabling connection.
2	Green	Off	Bad connection, or a break in the cabling.
3	Red	On	Data is being transmitted.
3	Red	Off	Data is not being transmitted.
4	Red	On	Data is being received.
4	Red	Off	Data is not being received.

FACTORY CONFIGURED SETTINGS
Switch	Setting
SW1/7	Not used
SW1/8	Not used