TRANSPORTER MODEL 8010-10440 Network Card Settings and Configuration

NIC Type	OmniNet (proprietary)
Network Transfer Rate	Unidentified
Data Bus	8-bit ISA
Topology	Linear Bus
Wire Type	Shielded/Unshielded twisted pair
Boot ROM	Available

CONNECTIONS
Function	Label
Unshielded or shielded twisted pair via 1/8" plug	CN1

USER CONFIGURABLE SETTINGS
Setting		Label	Position
»	Factory configured - do not alter	E2	Pins 1 & 2 closed

NODE ADDRESS
Setting	U14/1	U14/2	U14/3	U14/4	U14/5	U14/6
0	On	On	On	On	On	On
1	Off	On	On	On	On	On
2	On	Off	On	On	On	On
3	Off	Off	On	On	On	On
4	On	On	Off	On	On	On
59	Off	Off	On	Off	Off	Off
60	On	On	Off	Off	Off	Off
61	Off	On	Off	Off	Off	Off
62	On	Off	Off	Off	Off	Off
63	Off	Off	Off	Off	Off	Off
Note: A total of 64 node address settings are available. The switches are a binary representation of the decimal node addresses. U14/6 is the Most Significant Bit and switch U14/1 is the Least Significant Bit. The switches have the following decimal values: U14/6=32, U14/5=16, U14/4=8, U14/3=4, U14/2=2, U14/1=1. Turn off the switches and add the values of the switches that are off to obtain the correct node ID. (Off=1, On=0)

BIAS SELECTION
Setting	U14/7	U14/8
Normal	Off	Off
Biased	On	On
Note:Only one machine per network should be set to biased.

BASE I/O ADDRESS
Setting		E1/A	E1/B	E1/C	E1/D
	240h	Closed	Open	Open	Open
»	248h	Open	Closed	Open	Open
	250h	Open	Open	Closed	Open
	258h	Open	Open	Open	Closed
Note:E1 is a set of solder contacts. To change the address, you must cut the trace on E1/C andhard-wire a jumper with a soldering gun.