CS-FDDI VL Network Card Settings and Configuration

NIC Type	FDDI
Network Transfer Rate	100Mbps
Data Bus	32-bit VESA Local Bus
Topology	Ring
Wiring Type	Shielded twisted pair (location unidentified) Unshielded twisted pair (location unidentified) Fiber optic cable (location unidentified)
Boot ROM	Available (location unidentified)

USER CONFIGURABLE SETTINGS
Function		Label	Position
»	Boot ROM disabled	JP13/A	Open
	Boot ROM enabled	JP13/A	Closed
»	Factory configured - do not alter	JP13/E	Open
	Hard configuration mode selected	JP21/Pins 3 & 4	Open
	Soft configuration mode selected	JP21/Pins 3 & 4	Closed

BASE I/O ADDRESS SELECTION
Address		JP13/B	JP13/C	JP13/D
	200h-21Fh	Closed	Closed	Closed
	220h-23Fh	Closed	Closed	Open
	240h-25Fh	Closed	Open	Closed
	280h-29Fh	Closed	Open	Open
»	300h-31Fh	Open	Closed	Closed
	320h-33Fh	Open	Closed	Open
	340h-35Fh	Open	Open	Closed

INTERRUPT SELECTION
IRQ		JP2/A	JP2/B	JP2/C	JP2/D	JP2/E	JP2/F	JP2/G	JP2/H	JP2/I	JP2/J
	3	Open	Open	Open	Open	Open	Open	Open	Open	Open	Closed
	4	Open	Open	Open	Open	Open	Open	Open	Open	Closed	Open
»	5	Open	Open	Open	Open	Open	Open	Open	Closed	Open	Open
	7	Open	Open	Open	Open	Open	Open	Closed	Open	Open	Open
	9	Open	Open	Open	Open	Open	Closed	Open	Open	Open	Open
	10	Open	Open	Open	Open	Closed	Open	Open	Open	Open	Open
	11	Open	Open	Open	Closed	Open	Open	Open	Open	Open	Open
	12	Open	Open	Closed	Open	Open	Open	Open	Open	Open	Open
	14	Open	Closed	Open	Open	Open	Open	Open	Open	Open	Open
	15	Closed	Open	Open	Open	Open	Open	Open	Open	Open	Open

TECHNICAL NOTE

Notes: If software configuration is selected by closing JP21/pins 3 & 4, open jumpers JP13 and JP2. JP21/pins 1 & 2 function to toggle I/O address selection. If an I/O address collision is detected during installation, the shunt on JP21/pins 1 & 2 can be removed (while the PC is running) to force the software to try the next larger I/O address. For example, if a collision is detected using I/O address 300h, removing shunt on JP21/pins 1 & 2 will force the software to try I/O address 320h.