TNET16 Network Card Settings and Configuration
COMPEX, INC.
TNET16
NIC Type | Token-Ring |
Transfer Rate | 4/16Mbps |
Data Bus | 8/16-bit ISA |
Topology | Ring |
Wiring Type | Shielded twisted pair |
Boot ROM | Available (Also contains a built in RPL feature) |
BASE MEMORY ADDRESS | ||||||
Address | JP1 | JP2 | JP3 | JP4 | JP5 | JP6 |
C0000 - C1FFFh | Closed | Open | Open | Open | Open | Open |
C2000 - C3FFFh | Closed | Open | Open | Open | Open | Closed |
C4000 - C5FFFh | Closed | Open | Open | Open | Closed | Open |
C6000 - C7FFFh | Closed | Open | Open | Open | Closed | Closed |
C8000 - C9FFFh | Closed | Open | Open | Closed | Open | Open |
CA000 - CBFFFh | Closed | Open | Open | Closed | Open | Closed |
CC000 - CDFFFh | Closed | Open | Open | Closed | Closed | Open |
CE000 - CFFFFh | Closed | Open | Open | Closed | Closed | Closed |
D0000 - D1FFFh | Closed | Open | Closed | Open | Open | Open |
D2000 - D3FFFh | Closed | Open | Closed | Open | Open | Closed |
D4000 - D5FFFh | Closed | Open | Closed | Open | Closed | Open |
D6000 - D7FFFh | Closed | Open | Closed | Open | Closed | Closed |
D8000 - D9FFFh | Closed | Open | Closed | Closed | Open | Open |
DA000 - DBFFFh | Closed | Open | Closed | Closed | Open | Closed |
DC000 - DDFFFh | Closed | Open | Closed | Closed | Closed | Open |
DE000 - DFFFFh | Closed | Open | Closed | Closed | Closed | Closed |
Note:If a second card is to be installed in the same system, the second card should use address DC000 as its default. A maximum of two cards can be installed in a single system. | ||||||
INTERRUPT REQUEST | |||
IRQ | JP7 | JP8 | |
| » | 2/9 | Open | Open |
3 | Open | Closed | |
6 | Closed | Open | |
7 | Closed | Closed | |
SHARED RAM SIZE | |||
Size | JP9 | JP10 | |
8KB | Open | Open | |
| » | 16KB | Open | Closed |
32KB | Closed | Open | |
64KB | Closed | Closed | |
Note:RAM-Paging is only available with the 16KB setting. | |||
NETWORK SEGMENT SPEED | ||
Speed | JP11 | |
| » | 16Mbps | Closed |
4Mbps | Open | |
Note:All cards on the network segment must have this option set identically. | ||
PRIMARY/ALTERNATE SELECT AND I/O BASE ADDRESS | |||
Setting | I/O Address | JP12 | |
| » | Primary | A26 - A23h | Open |
Alternate | A24 - A27h | Closed | |
Note: If two cards are to be used in a single system, one of the cards must be set to primary and the other one must be set to alternate | |||
BOOT ROM | ||
Setting | JP13 | |
| » | Boot ROM disabled/Onboard RPL enabled | Open |
Boot ROM enabled/Onboard RPL disabled | Closed | |
Note:If you wish to use a boot ROM instead of the built-in RPL(Remote Program Load) JP13 should be set to closed. | ||
My Books
