T1015-4 Network Card Settings and Configuration

NIC Type	Token-Ring
Transfer Rate	4Mbps
Data Bus	8-bit ISA
Topology	Ring
Wiring Type	Unshielded twisted pair Shielded twisted pair (DB-9 port)
Boot ROM	Available

BOOT ROM SIZE
Size	JP1
32KB	Pins 2 & 3 closed
64KB	Pins 1 & 2 closed

BOOT ROM
Setting		JP2
»	Disabled	Pins 2 & 3 closed
	Enabled	Pins 1 & 2 closed

INTERRUPT REQUEST
IRQ	SW1/1	SW1/2	SW1/3	SW1/4	SW1/5	SW1/6
2	Off	Off	Off	Off	Off	On
3	Off	Off	Off	Off	On	Off
4	Off	Off	Off	On	Off	Off
5	Off	Off	On	Off	Off	Off
6	Off	On	Off	Off	Off	Off
7	On	Off	Off	Off	Off	Off

CABLE TYPE
Type	SW1/7
Shielded twisted pair (DB-9 port)	Off
Unshielded twisted pair	On

I/O BASE ADDRESS
Address	SW1/8
02A0h	Off
12A0h	On

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
LED1	Yellow	On	Data is being transmitted or received
LED1	Yellow	Off	Data is not being transmitted or received
LED2	Yellow	On	Card is receiveing power but is not attatched to network
LED2	Green	On	Card is attatched to network and is funtioning properly.
LED2	Red	On	Fault detected in network connection
LED2	N/A	Off	Card is not receiving power
Note:LED2 is a three color LED.