NC2000 REV. D Network Card Settings and Configuration
ANSEL COMMUNICATIONS, INC.
NC2000 REV. D
NIC Type | Ethernet |
Transfer Rate | 10Mbps |
Data Bus | 8/16-bit ISA |
Topology | Star Linear bus |
Wiring Type | Unshielded twisted pair RG-58A/U 50ohm coaxial AUI transceiver via DB-15 port |
Boot ROM | Available |
CABLE TYPE | ||
Type | JB1 | |
| » | Unshielded twisted pair | Setting 1 |
RG-58A/U 50ohm coaxial | Setting 2 | |
AUI transceiver via DB-15 port | Setting 3 | |
Note:See the diagram for an illustration of the settings. | ||
I/O BASE ADDRESS | |||
Address | SW1/1 | SW1/2 | |
| » | 300h | On | On |
320h | On | Off | |
340h | Off | On | |
360h | Off | Off | |
BOOT ROM ADDRESS | ||
Address | SW1/3 | SW1/4 |
C8000h | On | On |
CC000h | On | Off |
D0000h | Off | On |
D4000h | Off | Off |
INTERRUPT REQUEST | |||||
IRQ | SW1/5 | SW1/6 | SW1/7 | SW1/8 | |
2/9 | On | Off | Off | Off | |
| » | 3 | Off | Off | Off | On |
4 | Off | Off | On | Off | |
5 | Off | On | Off | Off | |
BOOT ROM | ||
Setting | W1 | |
| » | Disabled | Open |
Enabled | Closed | |
LINK INTEGRITY TEST | ||
Setting | W2 | |
| » | Enabled | Closed |
Disabled | Open | |
Note:The link integrity test is only valid when the cable type is unshielded twisted pair. | ||
COMPATIBILITY MODE | ||
Setting | W16 | |
| » | Disabled | Open |
Enabled | Closed | |
Note:You must enable compatibility mode if the card is installed in one of the following systems: Compaq 286 Portable, IBM PC Model 30, or a clone using a Chips & Technologies chipset. | ||
My Books
