ET-200STS Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	16-bit ISA
Topology	Linear Bus
Wiring Type	RG-58A/U 50ohm coaxial AUI transceiver via DB-15 port
Boot ROM	Available

ETHERNET VERSION
Version		JP1
»	Version 2 (IEEE 802.3)	Closed
	Version 1	Open

SEGMENT LENGTH
Maximum Length		JP2
»	185 meters	Closed
	300 meters	Open
Note:Segment length is the total length of cable between the two farthest cards on the segment. Each card on the segment must have this option set the same.

ONBOARD TERMINATOR
Setting		JP3
»	Disabled	Open
	Enabled	Closed
Note:If the card is on either end of a linear bus network segment, the onboard terminator may be used instead

DATA BUS SPEED
Speed		JP4
»	6-8MHz	Open
	8-16MHz	Closed

BOOT ROM SIZE
Size		JP5
»	8KB	Pins 2 & 3 Closed
	16KB	Pins 1 & 2 Closed

INTERRUPT REQUEST
IRQ		JP6	JP7	JP8	JP9	JP10	JP11	JP12
»	3	Open	Closed	Open	Open	Open	Open	Open
	2/9	Closed	Open	Open	Open	Open	Open	Open
	4	Open	Open	Closed	Open	Open	Open	Open
	5	Open	Open	Open	Closed	Open	Open	Open
	10	Open	Open	Open	Open	Closed	Open	Open
	11	Open	Open	Open	Open	Open	Closed	Open
	12	Open	Open	Open	Open	Open	Open	Closed

I/O BASE ADDRESS
Address		JP13	JP14	JP15	JP16
»	300h	Open	Open	Open	Closed
	320h	Open	Open	Closed	Open
	340h	Open	Closed	Open	Open
	360h	Closed	Open	Open	Open

BOOT ROM
Setting		JP17
»	Disabled	Open
	Enabled	Closed

BASE MEMORY ADDRESS
Address		JP18	JP19	JP20	JP21
»	D0000h	Closed	Open	Closed	Closed
	C8000h	Closed	Closed	Open	Closed
	CC000h	Closed	Closed	Open	Open
	D4000h	Closed	Open	Closed	Open
	D8000h	Closed	Open	Open	Closed
	DC000h	Closed	Open	Open	Open

CABLE TYPE
Mode		JP22 - JP29
»	RG-58A/U 50ohm coaxial	Pins 2 & 3 Closed
	AUI transceiver via DB-15 port	Pins 1 & 2 Closed